[Free] 2018(Aug) Ensurepass Cisco 200-401 Dumps with VCE and PDF 21-30

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 200-401
100% Free Download! 100% Pass Guaranteed!

Managing Industrial Networks with Cisco Networking

Question No: 21 DRAG DROP – (Topic 2)

Ensurepass 2018 PDF and VCE

Answer:

Ensurepass 2018 PDF and VCE

Question No: 22 – (Topic 2)

What is the purpose of Spanning Tree Protocol?

  1. to prevent routing loops

  2. to create a default route

  3. to provide multiple gateways for hosts

  4. to maintain a loop-free Layer 2 network topology

  5. to enhance the functions of SNMP

Answer: D

Question No: 23 – (Topic 2)

EtherNet/IP is an Ethernet implementation of which protocol?

  1. CIP

  2. Industrial Protocol

  3. DeviceNet

  4. ControlNet

Answer: A

Topic 3, Install, Replace, and Remove Cables

Question No: 24 – (Topic 3)

Which option best describes a mechanical, ingress, climatic, chemical and electromagnetic environment that is classified as M3 I3 C3 E3?

  1. the highest quality

  2. office environment

  3. severe

  4. serviced by multiple cable segments

Answer: C

Question No: 25 – (Topic 3)

With what are APC connectors used?

  1. Category 6a cables that need tight radius bends

  2. copper network cables in corrosive environments

  3. single-mode fiber-optic cables to reduce return loss

  4. high-density copper patch panels

Answer: C

Question No: 26 – (Topic 3)

What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?

  1. terminate in their characteristic impedance

  2. trim back and properly insulate

  3. connect to protective earth

  4. splice to a used conductor

Answer: A

Question No: 27 – (Topic 3)

Which characteristic causes multimode fiber-optic cable to differ from single mode?

  1. by allowing multiple network services in the same cable

  2. shorter maximum network segment length for a given bandwidth

  3. a wider variety of available connector types

  4. use outdoors as well as indoors

Answer: B

Question No: 28 – (Topic 3)

For which three issues should fiber-optic network segments be tested? (Choose three.)

  1. attenuation

  2. near-end crosstalk

  3. length

  4. polarity

  5. jitter

  6. tensile stress

Answer: A,C,D

Topic 4, Troubleshooting

Question No: 29 – (Topic 4)

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

  1. router#ping

  2. router#tracert

  3. router#show ip route

  4. router#show cdp neighbors

  5. router#traceroute

Answer: E

Question No: 30 – (Topic 4)

At which Layer would you check for spanning tree loops?

  1. Layer 1

  2. Layer 2

  3. Layer 3

  4. Layer 4

Answer: B

100% Ensurepass Free Download!
200-401 PDF
100% Ensurepass Free Guaranteed!
200-401 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No
         

You must be logged in to post a comment.

Proudly powered by WordPress   Premium Style Theme by www.gopiplus.com